Custom congruent to patient using:
Plaster, STS, Fiberglass Roll, 3D Scanner, Existing Positive Model
Current timing for delivery is 3 weeks.
Expedited on availability.
*Cast/Scan height must be 1" higher than desired
proximal trimline of the AFO
Custom congruent to patient using:
Plaster, STS, Fiberglass Roll, 3D Scanner, Existing Positive Model
Current timing for delivery is 3 weeks.
Expedited on availability.
*Cast/Scan height must be 1" higher than desired
proximal trimline of the AFO
Clinical Indications:
Recommended For:
Product Details
The Solid Ankle brace has been designed to offer the highest level of medial and lateral stability and control. The medial and lateral trim lines have been extended anterior to malleoli, increasing rigidity and restricting ankle movement.This brace must be worn with shoes to properly secure the foot. This device is constructed with a 4mm polypropylene shell that can be reduced to 3mm for flexibility or increased to 5mm or 6mm for greater control. For patients with a reducible valgus deformity or an inversion of the subtalar joint where the rearfoot is in varus, a valgus T-strap may be added to provide additional correction.
This brace is formed over a positive model of the patient’s foot. A negative impression or scan above the height of the finished brace must be created to correct and hold the foot, ideally with the ankle at 90 degrees and in a semi-weight-bearing or full-weight position.
This device is fully customizable per the practitioner’s discretion and is available exclusively through licensed medical providers.
SUGGESTED Codes
L1960 A rigid orthosis to control the foot and ankle, custom molded from a model of the patient, custom fabricated, includes casting and cast preparation
L2275 Addition to lower extremity, varus/valgus correction, plastic modification, padded/lined